Skip to content
Skip to SEARCH-3
Skip to CATEGORIES-2
Skip to ARCHIVES-2
Skip to META-2

dynode.nl

keratoconus, electronica en diverse onderwerpen

Shrunk Expand

Primary Navigation

  • Home
  • audiostreams
  • over/about
  • straling!
  • te koop/for sale
  • triops
← Older postsNewer posts→
  • Category Archives english
  • Baerveldt implantaat, 22 dagen later

    Posted on April 25, 2012 10:40 pm by Johan

    Portrait of eyes

    English summary below as usual

    Het is nu ongeveer 3/4 maand geleden dat bij mij een Baerveldt implantaat is geplaatst om mijn oogdruk onder controle te brengen. Ik heb over het algemeen weinig last van de operatie zelf gehad. Het oog voelde afgezien van wat prikjes (waarschijnlijk door hechtingen) en wat lichte doffe pijn, niet erg slecht aan over het algemeen. Het oog wordt langzaam minder rood en opgezwollen.

    Let op, enigszins bloedige foto in de rest van het artikel / Warning, safe for work but slightly bloody photograph after the break

    Continue reading → Post ID 1044


    english keratoconus medisch/medical Uncategorized 📎and tagged corneal transplant english glaucoma glaucoom keratoconus lens lenzen medisch/medical oog zicht
  • Easy GM tube connecting and testing

    Posted on March 28, 2012 11:20 pm by Johan

    Need a simple interface for connecting GM tubes to geiger counters? Use  1/4″ /6,35mm TRS sockets and plugs. It’s not what these plugs and sockets were designed for but it works nice. I use the tip as positive, ring as return and sleeve for ground. Two wires are sufficient to connect geiger tubes but the sleeve is connected to the ground of the circuit and to the shield of shielded cabling. You can also solder geiger tubes directly to the plug, I have done this with a SI-29BG tube and it works fine. Continue reading → Post ID 1044


    Electronica english wetenschap/science 📎and tagged english geiger counter radioactiviteit radioactivity
  • Basic scintillation setup

    Posted on March 17, 2012 6:29 pm by Johan

    crude scintillator setup

    Pictured above is my recently build scintillation setup. Scintillation detection is detection of radiation by means of a material that emits small pulses of light when struck by radiation. Most scintillation setups consist of a scintillation crystal, most often thallium doped potassium iodide, NaI(Tl) and a photomultiplier tube (PMT).

    The PMT is a very sensitive sensor which converts light pulses into electrons.  These electrons are multiplied by putting a high voltage across the cathode, a number of auxiliary electrodes called dynodes and the anode. The result is a clear pulse for each detected photon emitted by the scintillation crystal. Continue reading → Post ID 1044


    Electronica english wetenschap/science
  • Eye/Oog update: Baerveldt implant(aat)

    Posted on March 17, 2012 5:05 pm by Johan

    English summary below as usual

    Op 3 april zal ik een nieuwe operatie aan mijn rechteroog ondergaan. Het betreft het aanbrengen van een zgn. Baerveldt implantaat, een kunstmatig “ventiel”  om de oogdruk met minder of geen medicijnen laag te houden. Dit is nodig omdat ik momenteel de maximum dosis medicijnen tegen hoge oogdruk gebruik.

    Door de langdurige behandeling met corticosteroïden is er namelijk een permanent hogere oogdruk onstaan. De artsen willen de oogdruk met minder medicijnen behandelen aangezien deze bijwerkingen hebben (vooral de acetazolamide, prikkelende voeten en handen, misselijkheid) en ook een belasting voor het hoornvliestransplantaat zijn. Tevens is er geen reserve meer, als de oogdruk verder oploopt maken medicijnen niks meer uit waardoor verdere schade aan de oogzenuw kan optreden. Zoals ik eerder heb verteld is er al schade gezien maar deze is miniem en ligt buiten het centrale zicht waardoor ik er eigenlijk niks van merk. Continue reading → Post ID 1044


    english keratoconus medisch/medical 📎and tagged baerveld corneal transplant english eye glaucoma glaucoom hoornvliestransplantatie keratoconus lens lenzen medisch/medical oog surgery
  • Arduino environment monitor

    Posted on February 16, 2012 10:42 pm by Johan

    Above is a picture of my recently (practically ) finished project. It is a sort of weather station which measures light, temperature, relative humidity, atmospheric pressure, and of course radioactivity!

    The core of this setup is the excellent DIY Geiger Counter PCB by [Brohogan]. This kit is a geiger counter circuit combined with a standalone Arduino circuit. Most people buy this kit, connect an LCD and put it in a nice box. Because the Atmega328 pins are broken out via handy pin sockets it is very easy to connect any additional components and/or sensors to this PCB. Continue reading → Post ID 1044


    computers-networking Electronica english Uncategorized wetenschap/science 📎and tagged arduino bash english geiger counter linux radioactivity weather station

Posts pagination

Previous 1 … 4 5 6 … 12 Next

  • Categories

  • Archives

  • Meta

    • Log in
    • Entries feed
    • Comments feed
    • WordPress.org

©2025 raindrops Entries RSS and Comments RSS Raindrops Theme